www.lowering.nl
Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: [SEAT] [Ibiza 6K] 2.0 16V ABF vreemd motor gedrag

  1. #21
    Gasklephuis inleren gaat helaas niet bij deze motor en de digifrant 3.0 zie hier van gerrit speek

    Het inleren van het Gasklephuis kan worden uitgevoerd EN bij 'Drive-By-Wire' (DBW of E-gas) auto's EN bij auto's met een klassieke (Bowden) mechanische kabel, als er tenminste GEEN Idle Stabilization Valve (ISV) aanwezig is. Als die ISV wel aanwezig is dan is er geen gemotoriseerde controle van de gasklep.
    daarbij zijn alle label files die ik van de digifrant 3.0 heb zonder deze optie uitgerust of ik moet het niet zien

    ;************************************************* **********************************
    ; ECU : DIGIFANT 3.0
    ; FIRMWARE :
    ; ECU PART NUMBER : 037 906 024 G/AB
    ; MODELS COVERED : VW Golf III (1H) / VW Passat / SEAT Toledo & Ibiza
    ; ENGINE CODE : ABF
    ; REVISION HISTORY : 22/06/15 Rev 1.0
    ;************************************************* **********************************
    ;
    000,0,Basic Functions
    000,1,Intake air temperature,Specification: 73...24 (15...50 C)
    000,2,Battery voltage,Specification: 128...150 (12.0...14.2 V)
    000,3,Coolant temperature,Specification: 4...10 (85...105 C)
    000,4,Engine load,Specification: 60...90 (23...36 %)
    000,5,Lambda probe signal,Specification: 240...100 (0...1.0 V)
    000,6,Lambda control time counter,Specification: 0
    000,7,Lambda probe status counter,Specification: 0...20
    000,8,Throttle valve potentiometer voltage,Specification: 12...49 (0.25...0.95 V)
    000,9,Injection period,Specification: 5...8 (2.5...4.0 ms)
    000,10,Engine speed,Specification: 212...202 (770...890 rpm)
    ;
    ;Display Zone 7: When the Lambda probe does not supply a signal the counter counts high (e.g. probe cold).
    ; The value can rise to 127 when, for example, the probe heating or the probe wiring is defective.
    ; Check in "Read measured value block" function!
    ;
    ;Display Zone 4: The specifications are valid for an altitude up to max. 300m above sea level.
    ;
    ;Display Zone 3: Before initiating the basic setting the coolant temp value must be 4...10 (corresponds to 85...105 C).
    ;
    001,0,Basic Functions
    001,1,Coolant temperature,,Specification: 79...116 C
    001,2,Engine speed,,Specification: 780...900 rpm
    001,3,Lambda probe voltage,,Specification: 0...1.0 V
    001,4,Injection period,,Specification: 2.5...4.0 ms
    ;
    ; Injection period spec at idling, coolant temperature min. 80 C
    ;
    002,0,Idle Stabilization
    002,1,Coolant temperature,,Specification: 79...116 C
    002,2,Engine speed,,Specification: 780...900 rpm
    002,3,Throttle valve angle,,Specification: 0...86 <
    002,4,Engine load,,Specification: 23...36 %
    ;
    ; Engine load specifications are valid for an altitude up to max. 300 m above sea level.
    ;
    003,0,Group Functions
    003,1,Coolant temperature,,Specification: 79...116 C
    003,2,Engine speed,,Specification: 780...900 rpm
    003,3,Intake air temperature,,Specification: 12...70 C
    003,4,Battery voltage,,Specification: 10.8...15.0 V
    ;
    004,0,Operating Condition
    004,1,Coolant temperature,,Specification: 79...116 C
    004,2,Engine speed,,Specification: 780...890 rpm
    004,3,Ignition timing (calculated),, <
    004,4,Engine load,,Specification: 23...36 %
    ;
    ; Engine load specifications are valid for an altitude up to max. 300 m above sea level.
    ;
    005,0,Group Functions
    005,1,Coolant temperature,,Specification: 79...116 C
    005,2,Engine speed,,Specification: 780...900 rpm
    005,3,Throttle valve angle,,Specification: 0...86 <
    005,4,Battery voltage,,Specification: 10.8...15.0 V

  2. #22
    Vriend van SEAT-Online!
    Join Date
    08-08-2015
    Location
    Amsterdam
    Posts
    673
    Zoals ik het lees is het dan simpelweg niet nodig (het inleren). Is juist alleen maar handiger want dan scheelt dat weer.

Page 3 of 3 FirstFirst 123

Similar Threads

  1. [SEAT] [Ibiza 6J] 1.2TDi Ventilatie probleem, vreemd gedrag
    By LongTimeAgo in forum Overige Mechanisch
    Replies: 4
    Last Post: 18-04-2020, 14:45
  2. Replies: 5
    Last Post: 24-12-2019, 20:12
  3. [SEAT] [Ibiza 6L] Vreemd gedrag van de startonderbreker.
    By Mitsjel in forum SEAT Ibiza 6L (2002-2008)
    Replies: 6
    Last Post: 03-10-2014, 00:37
  4. [SEAT] [Ibiza 6J] Motor loopt vreemd
    By grimreaper161 in forum SEAT Ibiza 6J (2008-2017)
    Replies: 3
    Last Post: 24-02-2014, 22:18
  5. [SEAT] [Altea 5P] gaat spontaan op slot en vreemd gedrag binenverlichting
    By Frank Altea TDI in forum Elektrische Systemen
    Replies: 2
    Last Post: 25-11-2011, 15:01

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •